MODEL 702-N, 702-NSE and 702-NSS BUN SLICERS
0702S20037-1
MAINTENANCE/CLEANING/LUBRICATION
WARNING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL IT
HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND YOU
ARE SURE THE BLADE HAS STOPPED. ALSO REMEMBER TO USE
CARE WHENEVER YOU ARE WORKING NEAR THE BLADE.
MAINTENANCE
Other than normal cleaning and occasional blade replacement little other regular
maintenance is required.
CLEANING
Use a mild detergent solution or spray cleaner on all exterior and interior surfaces as
necessary. Periodically remove the OUTSIDE GUIDE AND CHUTE GUARD
ASSEMBLY and BLADE GUARD, then brush, or vacuum, all foreign material from below
the chute and from the blade compartment.
• Remove the BLADE GUARD by removing the three knobs which hold it in place. Lift
it clear of the machine and set it aside.
• Remove the OUTSIDE GUIDE AND CHUTE GUARD ASSEMBLY by loosening both
knobs which secure it in place, and then slide the assembly off the machine and set
it aside.
WARNING
ALWAYS USE CARE WHEN HANDLING AND CLEANING THE BLADE.
CONTINUED
To Next Page
Loading...
Need help?
General
