MODEL 702, 702SE and 702SS BUN SLICERS
REV. 8-28-96 0702S20024
TROUBLE SHOOTING
WARNING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL
IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND
YOU ARE SURE THE BLADE HAS STOPPED.
THE SLICER MOTOR WILL NOT START.
• Check to see if the machine is plugged in.
• If plugged in, is the outlet working? Test it with another, working, small appliance.
• Your slicer's motor is equipped with a thermal overload. Should the motor become
overheated it will stop. To restart allow the motor to cool for approximately five
minutes, then reset the overload by pressing the red button on the case of the motor.
• If you still can not find the problem have a qualified electrician check the unit's motor
and switch.
THE SLICER’S MOTOR WAS RUNNING BUT SUDDENLY STOPPED.
• Check to see if the machine's plug was accidentally removed.
• Your slicer's motor is equipped with a thermal overload. Should the motor become
overheated it will stop. To restart allow the motor to cool for approximately five
minutes, then reset the overload by pressing the red button on the case of the motor.
• If you still can not find the problem have a qualified electrician check the unit's motor
and switch.
To Next Page
Loading...
