4-71
Operation Panel
2 Press [OK]. The AppleTalk screen appears.
3 Press or to select whether AppleTalk is enabled.
4 Press [OK]. The AppleTalk setting is set and the Basic menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 In the Basic menu, press or to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press or to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Basic menu, press or to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
3 Press or to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu
reappears.
AppleTalk:
a
b
1
Off
********************-
2
*On
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
a
b
********************-
2
On
1
*Off
N
LAN Interface:
a
b
********************-
2
10Base-Half
3
10Base-Full
1
*Auto
To Next Page
Loading...
