139
Playback
7
Recording sound
Sound can be added to a still picture that you have already taken. (This is known
as “after-recording”.) You can also re-record over the sound that has already
been recorded. Total recording time per picture is approximately 4 seconds.
1 Use the arrow pad to select the
still picture you want to add
sound to.
2 In the top menu, select MODE
MENU Æ PLAY Æ
R.
g“How to use the menus” (P.35)
3
Press
d
to display START.
4 Turn the camera microphone toward
the sound you want to record and
press e to start recording.
• The BUSY bar is displayed during
recording.
• If the microphone is placed farther than 1 m (3.3 ft.) from the subject,
sound may not be recorded properly.
• If you re-record the sound, the original sound is erased.
• You may not be able to record sound when there is insufficient card
memory (the “CARD FULL” message is displayed).
• Sound recording may pick up camera noises, such as button
operation or shutter movement.
• Once sound is added to a picture, it is not possible to erase only the
sound. In this case, make a re-recording with silence.
Arrow pad
OK button
Microphone
CARDSEt EDIt
PLAY
StARt
Note
To Next Page
Loading...
