208
Troubleshooting
11
Miscellaneous
zWhen the camera is connected to a PC or printer.
Possible cause Corrective action Ref. page
The printer fails to connect.
PC was selected on the
monitor after connecting
to the printer with a USB
cable.
Remove the USB cable, and start again from
step 1 of “Connecting the camera to a
printer”.
P.185
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
—
The camera is not recognized by the PC.
The USB driver has not
been installed.
It is necessary to install the USB driver for
Windows 98/98SE. For installation
instructions, see “DIGITAL CAMERA-PC
CONNECTION OPERATION MANUAL” on
the CD-ROM.
—
The camera has not been
turned on.
Slide the power switch to q to turn the
camera on.
P.25
To Next Page
Loading...
