En
En 15
J CHANGING THE ANGLE OF THE MONITOR
You can change the angle of the monitor. This is useful for taking low-angle
shots where the viewfinder or monitor is hard to see.
1 Take hold of the monitor as shown in the illustration and pull it
out.
2 To take low-angle shots, position the monitor in the up position as
shown.
• The monitor can be positioned in the down position at an angle of 45 degrees
and in the up position at an angle of 22, 45 or 90 degrees.
• To take high-angle shots, position the monitor in the down position.
J SELECTING A LANGUAGE
1 Set the mode dial to C and turn the camera on.
• MODE MENU is displayed.
2 Press ac to select the SETUP tab, then press d.
3 Press ac to select W, then press d.
4 Press ac to select a language, then press e.
5 To turn the camera off, press the power switch again.
basic_e_d4155_6.fm Page 15 Monday, December 8, 2003 10:02 AM
To Next Page
Loading...
