En
En 39
J PROTECTING PICTURES
You are recommended to protect important pictures to avoid accidentally
erasing them. Protected pictures cannot be erased by the single-frame/all-frame
erase function.
1 Set the mode dial to q and turn the camera on.
• The monitor turns on.
2 Use the arrow pad or control dial to display the picture you want
to protect.
3 Press 0.
• To cancel protection, press 0 again.
• Protected pictures cannot be erased by the single-frame/all-frame
erase function, but they are all erased by formatting.
J ERASING PICTURES
This function lets you erase recorded pictures. Single-frame erase erases only
the picture displayed on the monitor and all-frame erase erases all the pictures
on the card.
• Once erased, pictures cannot be restored. Check each picture before
erasing to avoid accidentally erasing pictures you want to keep.
Single-frame erase
1 Set the mode dial to q and turn the camera on.
• The monitor turns on.
2 Use the arrow pad or control dial to display the picture you want
to erase.
3 Press S.
• The S ERASE screen is displayed.
4 Press ac to select YES, then press e.
• The picture is erased and the menu is closed.
All-frame erase
1 In the top menu, select MODE MENU → CARD → CARD SETUP,
and press d.
2 Press ac to select R ALL ERASE, then press e.
3 Press ac to select YES, then press e.
• All the pictures are erased.
Note
Note
basic_e_d4155_6.fm Page 39 Monday, December 8, 2003 10:02 AM
To Next Page
Loading...
