Check that the camera is set to the
Playback mode by holding down
the monitor button for a moment.
You can increase the number of images remaining on a card by erasing
unnecessary images.
Operating Procedure
1. Display the frame to erase by press-
ing the or arrow pad key.
(The frame can also be selected even when
the 4-split or 9-split display is selected.)
2. Press the OK/menu button.
[ The monitor shows the playback mode
menu 1/3.
3. Select by pressing the or
arrow pad key.
4. Select “YES” by pressing the or
arrow pad key.
5. Press the OK/menu button.
[ The selected image is erased.
The orange lamp on the right of the
viewfinder blinks during erasure.
To cancel single-frame erasure:
Select “NO” and press the
OK/menu button.
Once erased, images cannot be
restored. Check each image before
erasing to avoid accidentally
erasing images you want to keep.
To Next Page
Loading...
