You can run through all the stored pictures
automatically.
This function works when the lens barrier is closed.
1 Display the picture by turning on the LCD monitor ON/OFF
button (green button on rear).
2 Press the Function button to select the Slide-Show mode,
then press the OK (Shutter Release) button to start the
Slide-Show.
3 Press the Function button again to stop at the currently
displayed picture.
● The Slide-Show does not stop until you cancel the
operation. Press the Function button to stop it. (The power
turns off automatically after about 30 minutes regardless of
the power source.)
● The Slide-Show is also available in the Index-Display
mode. (p. 114)
To Next Page
Loading...
