Olympus CH30 - Power Supply Cord Selection Guide

E PROPER SELECTION OF THE POWER SUPPLY CORD
I no power supply cord is provided, please select the proper power supply cord for the equipment by referring
to "Specifications" and “Certified Cord" below:
CAUTION: In case you use a non-approved power supply cord for Olympus products, Olympus can no longer
warrant the electrical safety of the equipment
22
Specifications
Voltage Rating
Current Rating
Temperature Rating
Longih
Fittings Configuration
125V AC for 100-120V АС area) or, 250V AC (for 220-240V AC area)
Sam
soc
2.05 m maximum.
Grounding type attachment plug cap. Opposite terminates in molded-on
IEC configuration appliance coupling
Table 1 Certified Cord
A power supply cord should be certified by one of the agencies listed in Table 1, or comprised of cordage
marked with an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least,
‘one of agencies listed in Table 1. In case you are unable to buy locally in your country the power supply cord
which
is
approved
by
one
of
the
agencies
mentioned
in
Table
1,
please
use
replacements
approved
by
any
other equivalent and authorized agencies in your county.
EK | сту | доу | Сие
sonas | Na: O
ase [oe | GB E 7
Belgium cc | © Netherlands | KEMA | [REX
0000 | sa o ©
Denman | DEMO © |» =
cono [ue | sea [sv | (O
000 [woe [ONE SY
tard | Nal > is u | O