How to remove dust or stains visible in Olympus Microscope field of view?
If you notice dust or stains in the observed field of view of your Olympus Microscope, the eyepiece, condenser, window lens, or specimen slide are likely dirty. Clean these components thoroughly.
Why can't I focus my Olympus CX23?
If you cannot bring the specimen into focus because the stage cannot be raised on your Olympus Microscope, the pre-focusing knob is likely positioned too low. Raise its position.
Why is part of the image defocused on my Olympus Microscope?
If part of the image is defocused or looks like it's flowing in your Olympus Microscope, ensure that the objective is correctly engaged in the light path by rotating the revolving nosepiece until it clicks. Also, check that the specimen slide is properly placed on the stage and secured with the specimen holder.
Why is the observation image whitish, blurred, or unclear on my Olympus CX23?
A whitish, blurred, or unclear observation image on your Olympus Microscope can occur if the objective isn't correctly engaged in the light path. Ensure it's properly aligned by rotating the revolving nosepiece until it clicks. Also, check if the eyepiece, condenser, window lens, or specimen slide are dirty and clean them thoroughly. If using an oil immersion objective, confirm that you are using immersion oil, that there are no air bubbles in the oil, and that you are using the immersion oil provided by Olympus.
How to fix uneven brightness in Olympus CX23 field of view?
If the brightness of the observed field of view is uneven in your Olympus Microscope, it could be due to several reasons. First, check that the objective is fully engaged in the light path by rotating the revolving nosepiece until it clicks. Another possible cause is that the condenser is too low; raise it to its upper limit. Lastly, ensure that the objective, eyepiece, condenser, and window lens are clean.
What to do if observation image glares on Olympus CX23 Microscope?
If you're seeing glare in the observation image of your Olympus Microscope, it might be because the condenser is too low. Try raising it. Alternatively, the aperture iris diaphragm lever might be stopped down excessively. Adjust it according to the objective magnification you're using.
What to do if Olympus Microscope objective hits the slide before focusing?
If the high magnification objective hits the specimen slide just before the specimen comes into focus on your Olympus Microscope, the specimen slide is likely set upside down. Correct this by setting the specimen slide with the cover glass facing up.
How to adjust coarse adjustment knob tension on Olympus CX23?
If the rotation of the coarse adjustment knob feels too tight on your Olympus Microscope, the tension adjustment ring is probably set too tight. Loosen the tension adjustment ring to achieve the proper tension.
Discusses precautions to prevent infection during use and maintenance.
Guidelines for safe installation and electrical usage of the microscope.
Advice on careful handling, intended use, and proper maintenance.
Guide on correctly positioning a specimen slide on the microscope stage.
Steps for bringing the specimen into sharp focus using coarse and fine adjustment.
How to adjust the diopter for differences in eyesight between eyes.
General| Type | Biological Microscope |
|---|---|
| Observation Method | Brightfield |
| Objective Lenses | 4x, 10x, 40x, 100x (oil immersion) |
| Stage | Mechanical Stage |
| Illumination | LED |
| Condenser | Abbe condenser (NA 1.25) |
| Optical System | UIS2 (Universal Infinity System) |
| Magnification | 40x to 1000x |
| Power Supply | AC 100-240V, 50/60Hz |
| Eyepiece | 10x (FN 20) |
| Focusing | Coaxial coarse and fine focusing |
To Next Page
