Olympus CLH-SC - Disassembly and Assembly Procedures; Precautions for Disassembly and Assembly; Required Jigs and Tools; Assembly Procedure Overview

DISASSEMBLING/ASSEMBLING PROCEDURE
5. DISASSEMBLING/ASSEMBLING PROCEDURE
1. Precautions on Disassembling/Assembling
Replace the parts and wires to the original positions.
For electrical safety and standard, be sure to reassemble the following parts to the original
states.
Insulation tube and mylar sheet
Cables clamped and separated from the heating parts or high-voltage parts
Cover screws with a toothed lock washer to suppress a radiation noise
Use the specified parts.
The parts used in this unit are designed protective against vibration, heat and high voltage. Be
sure to select the parts with the same characteristics from the parts list when replacing the
parts.
Be careful when disconnecting the cable housing.
Don't pull the cable. Be sure to use the special tool.
2. Jigs and Tools
No.
1
2
3
4
Name
Phillips screwdriver No. 2
No.
OT0376
Specification
Remarks
3. Assembling
Reverse the disassembling procedure.
5-1