103076-01EN [U8998318], Rev. C, June 2014
Instrument Batteries 11
The status of the second docked battery (either charging = red or full = green) is also shown on the battery indicator located
on the left rear side of the docking station.
Figure 4-2 Battery charge status
4.2.2 Charging Batteries Using the Battery Charger
The battery charger is a standard accessory with the DELTA Element and DELTA Inspector models. It is an optional
accessory for all other models.
The charger takes about two hours to completely charge a battery. The battery charge status is indicated by two lights on
the power adaptor.
4.3 Hot Swap for a DELTA Battery
A battery hot-swap capability is a standard feature with the DELTA handheld XRF analyzer. You can remove and replace a
battery without having to shut down, restart, or perform a Cal Check.
A “shutdown” status display gives the percentage of internal charge remaining when the battery is removed (see
Figure 4-3 on page 11). If the internal charge reaches 0, insert a new battery and then, restart the analyzer with the I/O
switch. If the red X-ray indicator lights are flashing, the battery voltage is too low.
Figure 4-3 Shutdown status
Left light (green only) Right light (red only) Status
On — Flashing Off The battery is charging.
On — Solid Off The battery is charged.
Off On — Solid Error. Remove the battery, and then place it back on the
charger. If the error persists, call Olympus Technical Support.
Off Off There is no battery on the charger.
To Next Page
Loading...
