103158-01EN [U8998465], Rev. A, April 2012
6 Unfolding the Test Stand
Figure 3-2 Test chamber: Top view (looking straight down)
3.3 Electrical Requirements
You can use either the removable Li-ion battery (standard) or an AC adaptor (optional). You may also want to use the
DELTA docking station or a standard battery charger in the workstation area.
Both of the charging accessories require an AC power source.
4. Unfolding the Test Stand
To unfold the test stand
To avoid equipment damage, make sure that there is sufficient clearance when unfolding the test stand (see section 3.1 on
page 5).
1. Place the test stand on a table or a bench with its legs facing toward you (see Figure 4-1 on page 7).
2. Make sure that the locking levers are open (see Figure 4-1 on page 7).
3 Center of window to front wall 9.5 3.75
4 Center of window to rear wall 7 2.75
5 Internal height (lid closed) [not shown] 12.4 4.875
Component key cm in.
To Next Page
Loading...
