74
EN
Playback functions
8
8 Playback functions
The basic procedure for viewing pictures are as shown below.
However, before using any of these functions, follow Step 1 below. You can set the camera to
automatically switch to single-frame playback mode after shooting. g“REC VIEW” (P. 90)
1 Press the q button (Single-frame playback).
• The last recorded image appears.
• The LCD monitor turns off after more than 1 minute if no
operations are performed. The camera will turn off
automatically if there is no operation after 4 hours. Turn on
the camera again.
2 Use p to select images you want to view. You can
also turn the dial to switch to U for close-up
playback.
Single-frame/Close-up playback
j
INFO button
p
q button
L
N
15
15
Press p to change the
close-up position.
Press p to move the
display of the close-up
position.
When [g FACE DETECT]
(gP. 39) is set to [ON],
a frame is displayed
around a detected face.
Press i to move the
frame to another face.
Press bd to view frame-
by-frame close-ups.
When [g FACE DETECT]
is set to [ON], press ac
to move to another face in
close-up position.
• Press the INFO button
to return to close-up
playback.
(Single-frame playback) (Close-up playback)
Press the INFO button
a : Displays the frame that is
stored 10 frames back
c : Displays the frame that is
stored 10 frames ahead
d : Displays the next frame
b : Displays the previous frame
(Close-up position playback)
Press the INFO button
(Close-up frame-by-frame playback)
• To exit the playback mode, press the
q button again.
• Pressing the shutter button halfway
resumes the shooting mode.
s0029_e_00_0_unified.book Page 74 Monday, March 2, 2009 5:26 PM
To Next Page
Loading...
