EN 11
Shooting (TTL-AUTO)
In TTL-AUTO mode, the fl ash intensity is controlled automatically according to the camera
settings (ISO sensitivity and aperture value). Use this mode if the camera is equipped with
communication capability.
MODE button
1
Press the MODE button of the electronic fl ash
repeatedly to set the fl ash control mode to
[TTL AUTO].
2
By using the “Available shooting range” (Table p. 4)
as a guide, determine the distance to the subject and
then shoot.
When fl ash activation has been performed correctly, the
AUTO CHECK lamp blinks for about 5 seconds after
the shooting.
•
x
Notes
Some fl ash control modes are not available depending on camera settings or currently
selected shooting modes. It is not possible to select unavailable modes.
bookR210915L.indb11bookR210915L.indb11 2009/04/0916:19:432009/04/0916:19:43
To Next Page
Loading...
