Olympus FL-14 - Turning On the Electronic Flash

10 EN
Turning on the electronic fl ash
Turning on the electronic fl ash
Attach an electronic fl ash to the camera, and then turn the camera on with the fl ash.
TEST button/
CHARGE lamp
ON/OFF
button
1
Press and hold the ON/OFF button until any lamp
lights.
Press the ON/OFF button again to turn the power off.
2
When the CHARGE lamp lights, press the TEST
button to fi re a test fl ash.
Replace the batteries if the CHARGE lamp does not
light after:
• 30 seconds (Alkaline batteries)
• 10 seconds (NiMH batteries)
•
•
If the CHARGE lamp and AUTO CHECK lamp blink simultaneously, batteries are running
low. Replace the batteries.
If no operations are performed for about 15 minutes, the fl ash will enter sleep mode to
save power. The fl ash will also enter sleep mode whenever the camera enters sleep mode.
If no operations are performed for approximately 15 minutes more, the fl ash will turn off
automatically. Press the ON/OFF button to turn it on.
•
•
bookR210915L.indb10bookR210915L.indb10 2009/04/0916:19:432009/04/0916:19:43