Olympus LS-P2 - Page 73

4
73
EN
Extracting the speaking portions of files of spoken-word content [Voice Detect]
Extracting the speaking portions of files
of spoken-word content [Voice Detect]
When [ With recording ] is selected
1 Press the + or – button to select [On]
or [Off].
[On]:
Extract the speech portion while
recording.
[Off]:
Restores standard recording.
2 Press the `OK button.
• [Setting fixed] appears when the
process has finished.
6
Press the STOP ( 4) button to exit
the menu screen.
TIP
• When the voice detection process
has finished, the [Voice Playback]
item in the [Play Menu] is set to [On]
(☞ P. 62).
NOTE
• The message [No file] appears if you
select a folder that doesn’t contain
a saved file. You must select a folder
containing a file before you can
perform the process.
• The voice recorder may not be able to
properly extract non-silent portions
from files of non-spoken word
content such as recorded musical
performances.
• The voice recorder may not be able
to properly extract speaking portions
when they were low in volume when
recorded (level meter readout of -12 dB
or less), or due to surrounding noise.
• The time needed for the extraction
process will increase in proportion to
the size of the recorded file. Before
starting extraction, it’s recommended
to charge or replace the battery to
ensure it will not run out before the
process has finished.
• Using the [With recording] function
will make the battery deplete more
quickly.
• [With recording] function is only
available when [Rec Mode] is set to
[MP3] (☞ P. 56).
• The following functions are disabled
when using the [With recording]
function:
• [VCVA] (☞ P. 59)
• [V-Sync. Rec] (☞ P. 60)