Olympus µ-1070 - Selecting the video signal system to match your TV [VIDEO OUT]; Saving battery power between shots [POWER SAVE]; Turning off the camera sounds [SILENT MODE]

40 EN
Saving battery power between shots
[POWER SAVE]
E
SETUPPOWERSAVE
Submenu 2 Application
OFF Cancels[POWERSAVE].
ON
When
thecameraisnotbeing
usedforapprox.10seconds,the
monitorautomaticallyturnsoffto
savebatterypower.
To resume standby mode
Pressanybuttonorpressthezoomlever.
Selecting the video signal system to match your TV [VIDEO OUT]
E
SETUPVIDEOOUT
 TheTVvideosignalsystemvariesdependingonthecountriesandregions.Beforeviewingcamera
imagesonyourTV,selectthevideooutputaccordingtoyourTV’svideosignaltype.
Submenu 2 Application
NTSC ConnectingthecameratoaTVinNorthAmerica,Taiwan,Korea,Japan,andsoon
PAL Connecting
thecameratoaTVinEuropeancountries,China,andsoon
Thefactorydefaultsettingsdifferaccordingtotheregionwherethecameraissold.
To play back camera images on a TV
1 ConnecttheTVandcamera.
2 Use
thecameratoselectthesamevideosignalsystemastheoneofconnectedTV([NTSC]/
[PAL]).
3 T
urnontheTV,andchange“INPUT”to“VIDEO(aninputjackconnectedtothecamera).”
 FordetailsonchangingtheinputsourceoftheTV,refertotheTV’sinstructionmanual.
4 Presstheqbutton,anduseCEFDtoselecttheimageforplayback.
 DependingontheTV’ssettings,thedisplayedimagesandinformationmaybecomecropped.
Multi-connector
AVcable(supplied)
Connectorcover
Opentheconnectorcover
inthedirectionofthearrow.
ConnecttotheTV
videoinputjack(yellow)
andaudioinputjack
(white).
Turning off the camera sounds
[F SILENT MODE]
F
SILENTMODE
Submenu 1 Application
OFF
Theindividuallysetelectronic
soundsandvolumelevelsare
enabledin[SOUNDSETTINGS].
ON
The
electronicsounds(operating
sound,shuttersound,warning
sound)andplaybacksoundsare
muted.
 [SOUNDSETTINGS](p.37)