FLUSHING PUMP OFP
11
6.2 Repair
The OFP must only be serviced/repaired by suitably qualified technical personnel. If repair is required, contact
Olympus.
Olympus will not be responsible for damage or injury to equipment or personnel caused by unauthorised repair or
modification to this unit.
If the pump fails to operate:
D Check the items detailed in Section 11 Troubleshooting.
D Check the condition of both fuses located at the rear of the unit and the fuse in the power cable plug as appropriate.
CAUTION
The fuse must always be replaced with one of the correct rating. If the fuse continues to blow, stop using the
unit and contact Oly mpus or hospital engineer.
Always ensure the fuse drawer is pushed fully home following maintenance/repair, as failure to do so may
cause the mains power outlet to overheat.
Hold the unit with one hand to prevent it from moving, then insert the fuse drawer into the OFP mains power
inlet and push in until it clicks into position.
To Next Page
Loading...
