When you point the camera at the main subject and
press the spot button, the camera will measure the
brightness of the area where you position the outer edge
of the microprism and hold it in memory. This metered
value is kept in memory even if the camera angle is
changed afterwards. So you can recompose the shot in
whatever way you want.
Exposure selection can be achieved by simple operation
of the aperture and shutter speed rings after choosing
your favorite composition.
After the shot, spot metering is automatically disengaged
and center-weighted average light metering is restored.
When you want to cancel the input value immediately,
operate the clear lever. Even without doing so, input
value will automatically be canceled 60 seconds later.
Spot metering
Framing
59
To Next Page
Loading...
