Flash shooting
44
3
Basic shooting functions
1 Press the # button repeatedly to
set the flash mode.
g“Direct buttons” (P. 12)
• After 2 seconds of non-operation, the
selection is set and the mode selection
screen disappears.
• Each time you press # (flash mode),
the flash mode changes in the following
order.
•In S mode and M mode, the flash mode changes in the following order.
2 Press the shutter button halfway.
• In conditions where the flash will fire, the
# mark lights (flash stand-by).
3 Press the shutter button fully to
take the picture.
Note
• Since a slow shutter speed is automatically selected in low light situations when
in the flash off mode, the use of a tripod is recommended to prevent your
pictures from being blurred by camera movement.
AUTO
441600
To Next Page
Loading...
