Olympus SZ4045 - Page 53

SZ-CHI
C. REPAIR PROCEDURE
®
C-2
(4) Set the jig
Q).stand···SZ-ST + SZ-ILA
QD Polarizing plate ••• (A-PO, etc.)
* Adjust and fix the SZ microscope
direction by visual inspection
so that the polarizing plate
vibration direction and the SZ
microscope are not inclined.
(5) Adjust the polarizing plate vibration
to the arrow direction in the drawing
on the left.
(6) The analyzer Q)is fixed with
Shellac. Apply the mixture on it to
make the analyzer rotatable freely.
(7) Rotate the analyzer while monitor-
ing the polarizing plate through
the analyzer, and fix it when the
polarizing plate is seen most dark.
Adhesive SHELLAC (0Tll31)
l-2 Adjusting the_polarizer
(1) Reassemble the SZ microscope.
(For the disassembling method and
procedure, refer to the SZ3060
repair manual.)
* Do not remove the SZ-CHl until
the adjustment is finished.
(2) Attach the upper _[)a-rt@of SZ-CHI
to the lower part @)of it with the
insulated plate® interposed ·
therebetween.
Screw+ AB 3Xl2SA 3 pes.
,----- Pushing direction
~11