Olympus T32 - Shooting Without Flash Light

SH@TING
WITHOUT
FLASH
LIGHT
blink but instead
goes
out,
the subject is
too
far.
Choose a
larger
aperture or
get
closer to the
subject.
lf
you
want to take
pictures
with
existing light,
turn
the
T32 off; the charge lamp
goes
out and the
T32
will
ire even when
the capacitor
is
fully
charged.
lf the
signal stays
lit
{the
T32 did not fire):
The subject is
bright enough
and the
picture
was
taken
properly
by
existing
light.
The
flash
light
was
not needed.
'
In
case exposure
must
be achieved by
flash
illumination:
Turn
the aperture
ring until
the
meter
needle
points
to 1/3O sec.
or slower,
and shoot.
t0