Olympus TG-2 - Page 51

51
EN
Displaying the current altitude/water depth (atmospheric/hydraulic
Displaying the current altitude/water depth (atmospheric/hydraulic
pressure)
pressure)
d
d
[Manometer]
[Manometer]
Ɣ The readings may have a margin of error depending on meteorological conditions. Use the readings only for
your reference.
Submenu 1 Submenu 2 Submenu 3 Application
Tough Settings Manometer
Off Cancels the manometer display.
On
Displays the current altitude/water depth
(atmospheric/hydraulic pressure) in the
shooting standby mode screen. (–20 m to
5,000 m)
Calibrate Proceed to the setting screen. See below.
Ɣ When set to [On], a cautionary message appears if the water depth reaches 12 m (39.4 ft), followed by a
warning if the depth exceeds 15 m (49.2 ft).
To adjust the altitude/water depth display
To adjust the altitude/water depth display
1 Use FG to select [Calibrate], and press the A button.
2 Use FG to select the current altitude/water depth, and press the A button to set.
MENU
1200m1200m
Calibrate
Back
Setting the units of elevation, depth, etc.
Setting the units of elevation, depth, etc.
d
d
[m/ft]
[m/ft]
Submenu 1 Submenu 2 Submenu 3 Application
Tough Settings m/ft
m This displays in meters.
ft This displays in feet.