EN 14
EN
2. Maintaining the Waterproof Function
This product is sealed with an O-ring. Maintenance of the waterproof
function is required even before using this product underwater for the first
time.
Removing the O-ring
Open the battery cap and remove the O-ring from the flash.
1 Insert the O-ring remover between the O-ring and the wall of the O-ring
groove.
2 Move the tip of the inserted remover under the O-ring. (Take care not to
damage the O-ring groove with the tip of the remover.)
3 Hold the O-ring with your fingertips after it has come out of the groove and
remove it from the flash.
UFL-1_EN.book Page 14 Tuesday, February 20, 2007 6:09 PM
To Next Page
Loading...
