Omcan HLC300 User Manual

5
Installation
Operation
OMCAN DECLINES ANY AND ALL RESPONSIBILITY FOR DIRECT AND INDIRECT
DAMAGES WHICH MAY ENSUE FROM NOT COMPLYING WITH THE REGULATIONS.
THE CUTTING MACHINE IS MANUFACTURED INTO 110V/1/60HZ SETTINGS.
WARNING: OPEN THE COVER, ROTATE THE SIDE HANDLE AND REMOVE THE
CUTTING DISC (IF ANY) WITH THE MACHINE STOPPED, (OR WITH THE WHITE
PLASTIC EJECTOR ONLY), THROUGH THE UPPER (ROUND) OPENING. BY PRESSING
THE START GREEN BUTTON FOLLOWED BY THE RED STOP BUTTON, CHECK TO
MAKE SURE THE CENTRAL PIN DIRECTION OF ROTATION IS COUNTERCLOCKWISE.
IF THE DIRECTION OR ROTATION IS NOT CORRECT, REVERSE THE SUPPLY WIRES.
SAFETY MEASURES AND TRAINING
Theskilledpersonnelinchargeoftheinstallationandelectricconnectionsoftheequipmentisresponsiblefor
thetrainingoftheoperatorandinformingtheoperatorofallsafetymeasurestocomplywith.Thisinstruction
manualcomeswitheachunit.
CONTROLS
Thecontrolsandpilotlightareontherightsideofthebasewhenthe
machineislocatedinfrontoftheoperator.
1. Greenbuttonforstartingthemachine.
2. Redbuttonforstoppingthemachine.
Pic.2
Pic.3

Omcan HLC300 Specifications

General

Brand	Omcan
Model	HLC300
Category	Cutter
Language	English