Omega CN76000 - Page 6

4
3. To remove the logic jumper str ip , carefully inser t a small flat blade screwdr iver betw een the retaining
clip and the jumper at one end of the jumper str ip. Apply slight pressure to mo ve the clip a w ay from
the jumper end until it is released, then lift it up and out of the clip .
4. To re-install the jumper str ip , hold it with the spr ing contacts in the desired position. Face spr ings
up up
up up
up
for
SSRSSR
SSRSSR
SSR or
MECHANICAL RELA MECHANICAL RELA
MECHANICAL RELA MECHANICAL RELA
MECHANICAL RELA
YY
YY
Y outputs , or face spr ings
do do
do do
do
wnwn
wnwn
wn for
5 5
5 5
5
VdcVdc
VdcVdc
V d c outputs . Inser t one end
of the jumper str ip under the retaining clip and press the other end do wn until the remaining clip
engages the jumper.
5. To avoid an y damage, recheck the jumper installation and the housing rear ter minal panel output
wiring.
6. Replace the instr ument into its housing.
INPUT INPUT
INPUT INPUT
INPUT
WIRINGWIRING
WIRINGWIRING
WIRING
Do not r un ther mocouple or other input wir ing in the same conduit as pow er leads. Use only the type
of ther mocouple or RTD probe for which the control has been programmed. See the "Secure Menu"
for input selection.
For ther mocouple input always use extension leads of the same type designated for y our ther mo-
couple.