PLATINUM
TM
Series Controllers User’s Guide
M5451 Omega Engineering | www.omega.com
3.4 Connecting Outputs
The PLATINUM
TM
Series supports 7 different types of outputs with the model number numeric
designations summarized in Table 3. The unit comes preconfigured with up to 3 outputs (up to 6 outputs
with 1/8 DIN models). Table 3 shows the base output connector connections for the different
configurations offered. The base output configuration is the 3 numeric digits following the first dash in
the model number. The optional isolated output expansion board offered on 1/8 DIN models can add 1
or 3 additional isolated outputs with the numeric codes and connection positions shown in Table 3.
Table 4 defines the abbreviated codes used in Tables 5 and 6. Please note that the SPST and SPDT
mechanical relays have snubbers built in but only on the normally open contact side.
Table 3 – Output Type Designations for Base Output Connector.
3A Mechanical single pole, single throw (SPST) mechanical relay
1A Solid state relay (SSR)
3A Mechanical single pole, double throw (SPDT) mechanical relay
DC pulse for connecting to an external SSR
Analog current or voltage
Isolated Analog current or voltage (only on output expansion board for 1/8 DIN models)
Isolated DC pulse (“IDC” only on output expansion board for 1/8 DIN models)
Table 4 – 8 Pin Output/Power Connector Wiring Summary by Configuration.
DC pulse, DC pulse, DC pulse
DC pulse, DC pulse, analog
To Next Page
Loading...
