Need help?Do you have a question about the Omega MICROMEGA CN77000 series and is the answer not in the manual?
General| Display | Dual 4-digit LED |
|---|---|
| Mounting | Panel Mount |
| Control Algorithm | PID, On/Off |
| Control Mode | PID |
| Input Type | Thermocouple, RTD, Process |
| Output Type | Relay |
| Power Supply | 100-240 VAC |
| Communication | RS485 |
Overview of controller features, inputs, outputs, and optional modules.
Explains the characteristics of NEMA 1, 4, and 12 enclosures.
Essential safety instructions for installation and operation.
Guidelines for managing EMC issues.
How to get assistance and check product condition.
Information on obtaining documentation and software.
Instructions for physically installing the controller in a panel.
Description of the controller's front panel interface and rear panel connections.
Guide to configuring internal dip switches for various inputs.
Instructions for power connections and input signal wiring.
Explains the two primary operational modes of the controller.
Describes the role of each button during configuration.
Visual guides for configuring ID, setpoints, and input types.
Step-by-step process for setting or modifying the controller's ID.
Procedure for defining setpoint values when an ID is required.
How to map setpoints to control outputs.
Procedure for setting setpoints when the ID feature is not used.
Configuration options for various process input signals.
Guide to choosing and configuring thermocouple input types.
Details on selecting RTD types and their corresponding wiring.
Configuring the specific resistance values for RTD inputs.
Detailed options for configuring process voltage and current inputs.
Visual representation of the reading configuration menu.
Configuration of display decimal points and temperature units (°F/°C).
Adjusting the filter constant to control signal averaging.
Fine-tuning input scaling and offset for accurate readings.
Configuration steps for setting up both alarm channels.
Configuring alarm activation, control logic, and deviation modes.
Setting alarm latching, contact closure, and trigger conditions.
Configuring alarm behavior on power-up and setting high/low values.
Configuration steps for the second alarm channel.
Introduction to the loop break alarm feature and its configuration flow.
Activating the loop break alarm and setting its monitoring value.
Setting the time interval and temperature adjustments for loop break alarm.
Managing the ID code setting related to the loop break alarm.
Configuration for Output 1, including PID parameters and control types.
Configuration for Output 2, including PID parameters and control types.
Instructions for programming ramp and soak sequences.
Description of optional controller functionalities.
Details on command structure, syntax, and usage.
Table mapping commands to their indices and detailed functions.
Details on input types, control modes, outputs, and options.
Specs for communication, safety standards, and product approvals.
Information regarding Electromagnetic Compatibility standards met by the device.
Information regarding Low Voltage Directive and safety standards.
Details regarding the product warranty period and coverage.
Instructions for initiating product returns for warranty or repair.
To Next Page
