Set Points (if ID Number Enabled)
Display Action Response
SETPOINT 1
Press MENU 1) Press MENU, if necessary, until
"
SET PT
" prompt appears.
Press ENTER 2) Display advances to
"
SP1
", Setpoint 1.
DISPLAY SHOWS PREVIOUS VALUE. 1ST DIGIT FLASHING.
Press MAX 4) Press MAX to increase digit 0-9.
Press MIN 5) Press MIN to activate next digit (flashing).
6) Continue to use MAX and MIN to enter your 4-digit Setpoint 1 value.
Press ENTER 7) Display flashes
"
STRD
" message only if a change is made, otherwise press MENU to
advance to
"
SP2
", Setpoint 2.
SETPOINT 2 : DISPLAY SHOWS PREVIOUS VALUE. 1ST DIGIT FLASHING.
Press MAX & MIN 9) Use MAX and MIN buttons to enter your 4-digit Setpoint 2 value.
Press ENTER 13) Display flashes
"
STRD
" message and advances to ÒSwapping SetpointsÓ submenu.
STRD
210.5
SP2
210.5
STRD
100.5
SP1
100.5
SET
PT
part
3
O
PERATION
: C
ONFIGURATION
M
ODE
20
To Next Page
Loading...
