3.3 Comparing Code Numbers
The recorder will continue with its initialization process for about another 30
seconds. Locate the code numbers on the sensor calibration label. Refer to
Figures 3-5 and 3-6. The two-character Humidity Code you wrote down should
match the two-character code following the letter “H “on the label. If it does not,
refer to Section 5.1, Changing Calibration Codes.
The single character Temperature code should match the single-character code
following the letter “T” on the label. Refer to Figure 3-7. If it does not, refer to
Section 5.1, Changing Calibration Codes.
Figure 3-5. Location of Sensor Codes
Figure 3-6. Relative Humidity Code Location
Figure 3-7. Temperature Code Location
To Next Page
Loading...
