3.2 MOUNTING THE METER (Continued)
1. Cut a hole in your panel according to
the dimensions specified in Figure 3-3.
2. Insert the meter into the hole. Be sure
the front bezel is flush to the panel.
Figure 3-3. Panel Cut-Out
3. Proceed to Section 3.4 to connect your sensor input.
3.3 CONNECTING SENSOR INPUT
Figures 3-4 through 3-8 describe how to connect common sensor types.
Figure 3-4. 3-Wire dc Voltage Input Connection
with Internal Excitation
To Next Page
Loading...
