To Next PageTo Next Page
Need help?Do you have a question about the Omega DP25B-E and is the answer not in the manual?
General| Input Impedance | 10 MΩ |
|---|---|
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Electrical Connection | Screw terminals |
| Material | ABS plastic |
| IP Rating | IP65 |
| Display | 4-digit LED |
| Output | 4-20 mA |
| Power Supply | 10 to 32 VDC or 24 VAC |
| Process Connection | 1/4" NPT |
Important safety precautions for installation and operation, including EMC guidelines.
Explains the function of each pushbutton (SETPTS, ▲/MAX, ►/TARE, MENU, RESET) on the front panel.
Guides for connecting various DC voltage and current sensor inputs to the meter.
Instructions for safely connecting AC and DC main power to the meter.
Steps to select the appropriate input signal type for the meter's operation.
Guides for scaling meter readings to engineering units using calibration methods.
Detailed steps for calibrating the meter using known input signals and simulations.
Method for scaling the meter using transducer specifications and calculations.
Configuration options for Setpoint 1, including active band and latching.
How to set the active band, determining if the setpoint is active above or below the value.
Configuration for analog output, including enablement, type (current/voltage), and control mode.
Steps to enable or disable the analog output feature of the meter.
Scaling analog output to match display readings or specific engineering units.
