Omega DP25-S - Alarm Example

4
Configuring The Meter
36
Figure 4-1. Alarm Example
To reset latched alarms you must:
1. Input a signal OUT of the alarm zone
2. Then press SETPTS and then, RESET button
SIGNAL
LEVEL
SIGNAL
LEVEL
SIGNAL
LEVEL
ON ONOFF
ON
ON ON ON ON ON
ON
ON
ON
OFF
OFF
ONOFF OFF
OFF OFF
ACTIVE BELOW ACTIVE ABOVE
ACTIVE BELOW
WITH DEADBAND 3
ACTIVE ABOVE
WITH DEADBAND 3
ACTIVE BELOW LATCHED ACTIVE ABOVE LATCHED
SETPOINT
SETPOINT
SETPOINT
NOTE: DEADBAND WORKS AS HYSTERISIS
3
3
DEADBAND
Note
☞