47
Menu Configuration Displays
6
SECTION 6. MENU CONFIGURATION DISPLAYS (Continued)
Table 6-1. Menu Configuration Displays (Continued)
(Defaults in Bold and Italics)
MENU ∂TARE
ßNT/GRS
Press to scroll to the next Press to change the value of the flashing
Setpoint 1 Deadband
digit to the right digit
S1.DB
Press to scroll to the next Press to change the value of the flashing
Setpoint 2 Deadband
digit to the right digit
S2.DB
0.1 = 0.1=E (Analog output is enabled)
Output Configuration
0.1=D (Analog output is disabled)
OT.CF
0.2 = 0.2=C (Analog output is current)
0.2=V (Analog output is voltage)
0.3 = 0.3=N (Net reading)
0.3=G (Gross Reading)
Output Scale & Offset
Shows RD1 Changes the value of the flashing digit
OT.S.O
Shows prior value entered
and flashing digit.
Scrolls to the next digit.
Enter new value and Shows prior value entered Changes the value of the flashing digit
show OUT1 and flashing digit.
Scrolls to the next digit.
Enter new value and Shows prior value entered Changes the value of the flashing digit
show RD2 and flashing digit.
Scrolls to the next digit.
Enter new value and Shows prior value entered Changes the value of the flashing digit
show OUT2 and flashing digit.
Scrolls to the next digit.
1
3
2
4
6
7
5
(
Shown if O.3=A in Output
Configuration Menu OT.CF
)
To Next Page
Loading...
