18-5
Specifications
18
FLASHING MESSAGES
DURING PROGRAMMING (configuration mode)
NUMERICAL OVERFLOW: “999999”
OFFSET OVERFLOW: “ERR 01”
SETPOINT OVERFLOW: “ERR 02”
NOT STORED IN EEPROM: “NOSTOR”
VALUE PUT IN EEPROM: “STORED”
DURING MEASUREMENT (RUN MODE)
INPUT TOO LARGE, POSITIVE: “+ OVLD”
INPUT TOO LARGE, NEGATIVE: “– OVLD”
INPUT OUT OF RANGE, POSITIVE: “+ OPEN”
INPUT OUT OF RANGE, NEGATIVE: “– OPEN”
EXCESS INPUT SCALE/OFFSET: “I OVSC”
EXCESS DISPLAY SCALE/OFFSET: “R OVSC”
COUNT-BY DISPLAY OVERFLOW: “999999”
DURING SETPOINT ADJUST (RUN MODE)
OUT OF SELECTED DIGIT RANGE: “999999”
NOT STORED IN EEPROM: “NOSTOR”
VALUE PUT IN EEPROM: “STORED”
To Next Page
Loading...
