Omega DP461-S - Page 8

Figure 7-9 AC Connector Wiring at P1 ................................................7-4
Figure 7-10 DC Connector Wiring at P1 ................................................7-4
Figure 8-1 S3 and S4 Main Board Jumper Positions...........................8-2
Figure 8-2 S1 and S2 Signal Input Jumper Positions ..........................8-3
Figure 8-3 Internally-Powered Bridge Input .........................................8-4
Figure 8-4 S3 and S4 Main Board Jumper Positions.........................8-16
Figure 8-5 S1 and S2 Signal Input Jumper Positions ........................8-16
Figure 8-6 Sensor Input Connections ................................................8-17
Figure 8-7 S3 and S4 Main Board Jumper Positions.........................8-28
Figure 8-8 S1 and S2 Signal Input Jumper Positions ........................8-29
Figure 8-9 Sensor Input Connections ................................................8-29
Figure 8-10 S3 and S4 Main Board Jumper Positions.........................8-41
Figure 8-11 S1 and S2 Signal Input Jumper Positions ........................8-42
Figure 8-12 Sensor Input Connections ................................................8-42
Figure 10-1 Setpoints 1 & 2 Action ......................................................10-2
Figure 10-2 Setpoints 3 & 4 Action ......................................................10-2
Figure 10-3 Process Deviation ............................................................10-4
Figure 10-4 High Deviation for both Active Above and Active Below...10-4
Figure 10-5 Low Deviation for both Active Above and Active Below....10-5
Figure 10-6 Band Deviation for both Active Above and Active Below..10-5
Figure 10-7 AL CNF Hysteresis ...........................................................10-6
Figure 12-1 Analog Option Board and Connection Diagram at P5. .....12-3
Figure 12-2 Isolated Analog Output Board Wiring Connections. .........12-5
Figure 13-1 BCD 40-Pin Cable Connector (P8)...................................13-1
Figure 13-2 BCD Option Board............................................................13-2
Figure 13-3 Address Programming Chart for 4 -line Address..............13-5
Figure 14-1 Dual Relay ........................................................................14-1
Figure 14-2 4 Relay Board Jumpers and Plugs ...................................14-2
Figure 14-3 Dual Relay Output Board Wiring Connections .................14-3
Figure 14-4 4 Relay Output Board Wiring Connections.......................14-3
Figure 15-1 RS-232/RS-485 Option Board and Pin Designations .......15-1
Figure 15-2a Older RS-232 Option Board and Pin Designations ..........15-1
Figures
vi