-/+ knob acts on the time of day by default.
- Turn the selector left/right, the hours flash.
- Modify the flashing hours value turning the selector left/right.
- Push the Temp&Time selector to switch back and forth between hours and minutes.
- Modify the flashing minutes turning left/right.
- After a few seconds the whole time of day value starts flashing: wait until the new
time of day is steady.
Fig. 9a
Push the knob to toggle between the time of day and the minute minder and check the
set values. The clock is selected by default while the
symbol appears when the minute
minder is displayed.
Setting the minute minder
When the symbol is displayed, turn the knob left/right in order to set the timer value.
The standard value is 30 minutes, it’s possible to modify it in the range between 0 and
240 minutes.
This timer has no influence on the oven activities and can be set also when the oven is
off. The time of day is displayed with priority in any case, the
symbol shows the minute
minder is active.
When the time expires, the symbol flashes and the buzzer sounds a warning sequence
(two short beeps repeated every 3 seconds) to recall the user attention. Push the knob
to stop it.
The buzzer stops in any case after a time-out.
To Next Page
Loading...
