Omega OO6A1X - Electricals

3
INSTALLATION OF THE OVEN
To install the oven into the kitchen a cutout should be made in accordance with the
dimensions shown in Fig. 1.
The apparatus is to be fastened to the top by means of the two screws provided in the kit
through the holes made on the oven uprights.
The cabinet in which the apparatus is installed shall be open on the back side to ensure a
sufficient air circulation and prevent overheating.
Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a
column; this is not necessary if the oven is installed under the work top.
WARNING
As the
apparatus is to be fitted in your kitchen furniture, make
sure that all surfaces in contact with the oven can resist a
temperature of approx. 90°C.
Electricals
- Absorbed po wer:
Oven top element:................................................................... 2000+1000 W
Oven bottom element: ............................................................ 1200+400 W
Round element (hot air): ......................................................... 2300 W (on some models)
roasting jack motor: ............................................................... 4 W (on some models)
lamp: ....................................................................................... 25 W
Hot air fan motor:...................................................................... 25 W
Cooling fan motor:..................................................................... 25 W
- Maximum absorbed
power: (see data plate).
- Supply voltage
: (see data plate).