-  Turn the knob left/right, the hours flash. 
-  Modify the flashing hours value turning the knob left/right. 
-  Push the knob to switch back and forth between hours and minutes or wait a few 
seconds until the minutes flash. 
-  Modify the flashing minutes value the knob left/right. 
-  Wait until the new End of Cooking time value stops flashing. 
 
 
The  display  will  flash  End  and its value  alternatively  for a few  seconds  then  it will 
show the time of day, the 
 symbol and the     letter to indicate that  a timed cooking 
is active. The cooking duration is updated automatically. 
 
 
3. Repeat  the  same operations  of point 1 then push  the knob  until End  appears.  the 
control shows the “current time + cooking time” as the initial stop time. It’s not possible 
to lower the end of cooking time below this value. In order to set the actually desired 
end of cooking time in a 24 hours range: 
 
 
-  Turn the knob left/right, the hours flash. 
-  Modify the flashing hours value turning the knob left/right. 
-  Push the knob to switch back and forth between hours and minutes or wait a few 
seconds until the minutes flash. 
-  Modify the flashing minutes value turning the knob left/right. 
-  Wait until the new End of Cooking time value stops flashing. 
 
 
The  display  will  flash  End  and its value  alternatively  for a few  seconds  then  it will 
show the time of day and the 
 letter to indicate that  a delayed cooking has been 
programmed.  As soon as the delay time expires, the oven starts and works for the 
programmed cooking time. The 
 symbol is displayed. 
 
At  the  end  of  any  timed  activity  the  control  shuts  down  the  oven,  the  buzzer  sounds 
a warning  sequence  (two  short  beeps  repeated  every  3 seconds)  to  recall  the  user 
attention,  for a maximum  time and makes  the time related icons (
,  ) flash  on the 
display. Push the knob to silent the buzzer and reset the warning message. 
 
 
Turn the mode selector to ZERO (OFF) position before reusing the oven. 
 
 
 
Oven 
functions
 
The control can manage  many cooking  functions,  here  below described,  their  number 
and  availability  depends  on  the  oven model.  The  temperature  range  is between 50°C 
and  250°C  for most  functions.  Preset  temperatures  are  mainly  190°C  for  convection 
modes, 210°C for thermal modes and 230°C for grilling functions. 
 
 
Exceptions are Eco-Bake (preset=190°C), Pyrolyse (fixed 475°C), and low temperature 
modes (Light, Defrost, Keep Warm).