What to do if the light and motor on my Omega Ventilation Hood do not work?
If the light and motor on your Omega Ventilation Hood aren't working, the house fuses might be blown, in which case you should reset or replace them. Alternatively, the power cord may be loose or disconnected. Ensure the cord is properly fitted to the power outlet and the outlet is switched on.
Why does my Omega ORU70MB Ventilation Hood have insufficient suction?
If your Omega Ventilation Hood isn't providing sufficient suction, it might be because the distance between the rangehood and the gas top is too far. Try refitting the rangehood to the correct distance.
What to do if my Omega ORU70MB Ventilation Hood is leaking oil?
If your Omega Ventilation Hood is leaking oil, it could be due to a couple of reasons. First, the one-way valve and the air ventilation entrance might not be tightly sealed. To fix this, take down the one-way valve and seal it with sealant. Second, there might be leakage from the connection of the U-shaped section and cover. In this case, take the U-shaped section down and seal it.
Why is the light on, but the motor does not work on my Omega Ventilation Hood?
If the light is on but the motor of your Omega Ventilation Hood isn't working, it could be due to a few reasons. The fan switch might be turned off; if so, select a fan switch position.
How to fix an Omega Ventilation Hood that inclines?
If your Omega Ventilation Hood inclines, the fixing screws are likely not tight enough. Tighten the hanging screw to make it horizontal.
General| Brand | Omega |
|---|---|
| Model | ORU70MB |
| Size | 70cm |
| Width | 700mm |
| Finish | Stainless Steel |
| Motor | Single |
| Number of Motors | 1 |
| Speeds | 3 |
| Lighting | Yes |
| Lighting Type | LED |
| Filter | Yes |
| Control Type | Push Button |
| Noise Level | 65dB |
| Material | Stainless Steel |
| Type | Undermount |
| Filter Type | Aluminium |
To Next Page
