SECTION 4 - LASER SIGHT ACCESSORY
4.1 – Warnings and Caution
You may receive harmful laser radiation exposure if you do
not adhere to the warnings listed below:
• USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED IN THIS GUIDE MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
• DO NOT LOOK AT THE LASER BEAM COMING OUT OF THE LENS OR
VIEW IT DIRECTLY WITH OPTICAL INSTRUMENTS – EYE DAMAGE CAN
RESULT.
• USE EXTREME CAUTION WHEN OPERATING THE LASER SIGHT
ACCESSORY.
• NEVER POINT THE LASER ACCESSORY AT A PERSON.
• KEEP THE LASER SIGHT ACCESSORY OUT OF REACH OF ALL
CHILDREN.
Do not attempt to open the laser sight accessory. There are no
user serviceable parts inside.
4.2 – Operating the Laser Sight Accessory
The laser sight accessory screws onto the front of the transmitter sensor head.
This accessory is only used for alignment of the transmitter head to the target
area. After the alignment process, the accessory has to be removed from the front
of the transmitter head before temperature measurement is made.
The laser sight accessory is powered from a small, compact battery pack
(included with the accessory). Connect the battery pack to the accessory using
the cable provided. Aim at the target, and turn on the battery power using the
slide switch on the battery pack. Adjust the sensor head position so that the laser
beam points to the center of the target area. Turn off the battery pack, and
remove the laser sighting accessory from the sensor head (Fig 4-1).
CAUTION:
WARNING:
Laser Sight Accessory
4
7
To Next Page
Loading...
Need help?
General
