CIBANO 500 Getting Started
6 OMICRON
1.3.5 Measurement setup
► Only use test leads and tools which provide full protection against direct contact.
► Always insert connectors completely and use the interlock mechanism.
► Press the Emergency Stop button on the CIBANO 500 front panel while connecting the test leads
to the test object.
► Do not insert objects (for example, screwdrivers) into any input/output socket.
1.3.6 Perform tests
► Stay in the safe area during test.
► Make sure that nobody is within the high-voltage test area.
► Warn people prior any operation to make them aware of any possible disturbances.
1.4 Orderly measures
The CIBANO 500 Getting Started or alternatively the e-book has always to be available on the site where
CIBANO 500 is operated.
The users of CIBANO 500 must read this manual before operating CIBANO 500 and observe the safety,
installation, and operation instructions therein.
CIBANO 500 and its accessories may be used only as described in this Getting Started. Any other use
is not in accordance with the regulations. The manufacturer and the distributor are not liable for damage
resulting from improper usage. The user alone assumes all responsibility and risk.
Following the instructions provided in this Getting Started is also considered part of being in accordance
with the regulations.
Opening CIBANO 500 or its accessories invalidates all warranty claims.
1.5 Disclaimer
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
To Next Page
Loading...
Need help?
General