3
Advanced Partial Discharge Measuring System MPD 600
1 Setting up your System
Figure 1: MPD 600 advanced partial discharge measuring system with coupling capacitor
This quick start guide will lead you step-by-step from setting up the MPD 600 advanced partial
discharge (PD) measuring system to performing your first measurement.
The black dot (•) indicates where actions are required on your part.
Upon unpacking the system you will find one fiber optics controller MCU 502 and one or more
MPD 600 acquisition units. Beside them you will find the appropriate measuring impedance(s)
CPL 542, power supply, battery, charger and various measurement and fiber optical cables.
To Next Page
Loading...
