To Next PageTo Next PageWhat to do if the status light is flashing red on my Omnex Receiver?
If the status light on your Omnex Receiver is flashing red, it indicates that one of the input/output wires has been connected to the power source. Inspect the wiring, looking for short circuits, such as bare wires. If the problem continues, it is recommended to call for service.
What to do if there is a short to supply in Omnex R160?
If there's a short to supply in your Omnex Receiver, disconnect A & B connectors from the receiver and check all outputs for power, looking for issues like bare wires or improper connections; then make the correct adjustments. If the issue persists, call for service.
What to do if Omnex R160 Receiver didn’t receive all of the information?
If the Omnex Receiver didn’t receive all the information, try the downloading steps again. If that doesn’t solve the problem, send both the transmitter and receiver in for service.
General
