To Next PageTo Next PageWhat to do if the status light is flashing red on my Omnex Generic 5SW?
If the status light on your Omnex Receiver is flashing red, it indicates that one of the input/output wires has been connected to the power source. Inspect the wiring, looking for short circuits, such as bare wires. If the problem continues, it is recommended to call for service.
What to do if there is a short to supply in Omnex Generic 5SW Receiver?
If there's a short to supply in your Omnex Receiver, disconnect A & B connectors from the receiver and check all outputs for power, looking for issues like bare wires or improper connections; then make the correct adjustments. If the issue persists, call for service.
What to do if Omnex Generic 5SW didn’t receive all of the information?
If the Omnex Receiver didn’t receive all the information, try the downloading steps again. If that doesn’t solve the problem, send both the transmitter and receiver in for service.
Lists key features of the ORIGA T150/R160 system, including approvals, range, and design.
Details the internal wiring of the R160 receiver and its pin-out functions.
Shows the pin assignments for Connector A (Grey) and Connector B (Black) of the receiver.
Provides guidance on how and where to mount the receiver for optimal performance.
Details best practices for connecting power and wiring for the system components.
Recommends installing diodes for solenoid/switch control to prevent circuit back-surge.
Instructions for installing AA alkaline batteries into the T150 transmitter.
Steps to power on the T150 transmitter, referencing the Light Legend.
Instructions on how to open the R160 receiver case using a screwdriver.
Steps to prepare the T150 transmitter and power the R160 receiver.
Guides on powering the T150 transmitter into configuration mode.
Instructions to put the R160 receiver into setup mode.
Steps to download the transmitter's ID code to the receiver.
Steps to prepare the T150, power it into configuration and calibration modes.
Guides on setting the minimum and maximum levels for proportional controls.
Final step to power off the transmitter after calibration.
Explains various light indicators and their meanings during operation and diagnostics.
Describes normal operational states of the receiver indicator lights.
Lists indicator lights, their descriptions, and corresponding solutions for troubleshooting.
Flowchart for diagnosing issues with the R160 receiver based on indicator lights.
Flowchart for diagnosing issues with the T150 transmitter based on indicator lights.
Flowchart for diagnosing communication issues between transmitter and receiver.
Discusses potential issues and solutions during the ID download process.
General
