To Next PageTo Next PageWhat to do if the fuse is blown in my Omnex T150 Receiver?
If the fuse is blown in your Omnex Receiver, the suggested solution is to change the fuse. Additionally, inspect the wiring to check for short circuits, such as bare wires. If the problem continues to occur after these steps, it is recommended to call for service.
What to do if the Link light on the Omnex T150 doesn't turn green?
If the Link light on the Omnex Receiver does not turn GREEN when the power switch is toggled on the transmitter to download, try the downloading steps again.
What to do if there is a short to supply in my Omnex Receiver?
If there is a short to supply in your Omnex Receiver, disconnect A & B connectors from the receiver and check all outputs for power, looking for issues like bare wires or improper connections. Make the necessary adjustments. If the problem persists, it is recommended to call for service.
What to do if 2 output wires are connected in my Omnex Receiver?
If you observe that 2 output wires are connected and the indicator comes on when a function is pressed on your Omnex Receiver, disconnect each output wire one at a time and press the function button. If the light clears, that output is incorrectly connected. Continue this process for each output until all output wires have been identified.
What to do if the E-Stop wire is connected to another output wire in my Omnex T150?
If the E-Stop wire is connected to another output wire in your Omnex Receiver, inspect the wiring and look for improper connections.
What to do if the status light is flashing red on my Omnex T150?
If the status light on your Omnex Receiver is flashing red, it indicates that one of the input/output wires has been connected to the power source. Inspect the wiring, looking for short circuits, such as bare wires. If the problem continues, it is recommended to call for service.
What to do if there is a short to supply in Omnex Receiver?
If there's a short to supply in your Omnex Receiver, disconnect A & B connectors from the receiver and check all outputs for power, looking for issues like bare wires or improper connections; then make the correct adjustments. If the issue persists, call for service.
What to do if Omnex Receiver didn’t receive all of the information?
If the Omnex Receiver didn’t receive all the information, try the downloading steps again. If that doesn’t solve the problem, send both the transmitter and receiver in for service.
General
