Tighten all screws, bolts and lock nuts of every adjustable mechanical element following
normal tightening values, without using any levers or hitting any spanners.
Never climb onto the machine while operating.
All plates and pictograms must be kept entirely readable. If the identification plate
deteriorates with use and turns unreadable, even just partly, a new one should be
requested from the Builder, referring to the data contained in this manual or written on
the original plate.
Do not c
lean or lubricate any parts of the machine when operating.
Do not c
lean the machine with water nor aggressive products, even if diluted.
Omni SUPERPLUS EN IGM_REV6 13
To Next Page
Loading...