THE IDENTIFICATION PLATE MUST NEVER BE REMOVED.
1.10 GENERAL SAFETY INFORMATION
During project and manufacturing phases, the Builder paid careful attention to all those situations
that might cause risks to the safety and the health of people. The relevant laws were fully
respected and all the “rules of good building technique” were applied. The aim of this type of
information is to raise the awareness of users on the importance of preventing any risk, always
using caution.
Carefully read t
he information reported in the manual and placed directly on the machine,
especially safety information.
Please read thi
s manual carefully before using or servicing the machine.
Do not tamper
with, sidestep, eliminate or bypass the safety and warning devices
installed on the machine. Non-compliance with this requirement can cause serious risks
and can compromise the safety of people.
Omni SUPERPLUS EN IGM_REV6 10
sales@omnigroup.com.au
www.omnigroup.com.au
Ph : 1300 764 963
To Next Page
Loading...